Case Studies

An aerospace manufacturer was machining 30 back spot facings in a component made of Inconel 718 for some years. To do this, the part needed to be set up several times because of the poor accessability...

A major heavy equipment manufacturer was looking for a solution to produce countersinks on bores for a gear component on a tractor.

A subcontractor to the engineering industry was looking for a solution to apply back spot faces for the bolting that does the job without the time-consuming reclamping of the workpiece. The time used ...

This aerospace manufacturer was looking for a solution for deburring three through-holes with four bore edges each for a fuel pump component on a rocket. 

A precision machining supplier to the automotive industry who produces more than 1 million common rails per year was looking for a solution to automate the back deburring of a low pressure bore.

A manufacturer of motorsport engines was looking for a cost-effective solution for the application of counterbores.

A Precision Machinist was looking for a solution to deburr the cross bores of a pipe for industrial cleaners automatically front and back. The difficulty here was the accessibility of the back bore ed...

A major manufacturer of jet engine and aircraft components wanted to replace the manual hand benching to deburr an Inconel part. Their goal was to automate that process to save both labor and time. 

A manufacturer in the automotive industry produces about 12 million aluminium wheels for passenger vehicles per year. The customer was looking for a solution to produce the wheel mounting bore cost-ef...

A manufacturer of wind rotors was looking for a more efficient and stable solution for the application of back spot faces to bores.